...and it's a slightly different process than the we easyStore from Best Buy.
If you've done the easyStore or watch the YouTube videos, the drive is easily removed from the internal carriage or frame by tipping up the side opposite the connectors while holding it label side down. Easy Peasy.
The B&H Elements is slightly different. It doesn't tip up like the easyStore. It's held in place by four rubber holders at each corner. You have to remove the light pipe first, then push up slightly on the same side as you would the easyStore. Wiggle the plastic frame a bit and you can pull the rubber holders off the two elevated corners and pull the drive forward, up and out. Not really a big deal, just not easypeasy.
The USB board is removed with two Phillips screws instead of one and one Torx. Done.
I don't know if the change in design is just an update or specific to the B&H version of the WD. But all bits are reusable with a spare bare drive. I put a 4T drive in the last one and will do the same with this.







I am that Masked Man.
All you can do, is all you can do.
There’s trouble — it's time to play the sound of my people.
Your boos mean nothing to me, I've seen what you cheer for.
Insisting on your rights without acknowledging your responsibilities isn’t freedom, it’s adolescence.
I've been to the edge of the map, and there be monsters.
We are a government of laws, not men.
Everybody counts or nobody counts.
When a good man is hurt,
all who would be called good
must suffer with him.
You and I have memories longer than the road that stretches out ahead.
There is no safety for honest men except
by believing all possible evil of evil men.
We don’t do focus groups. They just ensure that you don’t offend anyone, and produce bland inoffensive products. —Sir Jonathan Ive
An armed society is a polite society.
And hope is a lousy defense.
You make me pull, I'll put you down.
I *love* SIGs. It's Glocks I hate.